La Pavoni Lever gaskets service kit for Pre Mill machines – LIGHT VERSION

La Pavoni Lever gaskets service kit for Pre Mill machines – LIGHT VERSION is used to overhaul almost your entire OLD GEN machine.

This kit is suitable for all La Pavoni Europiccola or Professional manufactured before year 2000.

La Pavoni Lever gaskets service kit for Pre Mill machines – LIGHT VERSION contains the most prone to warn seals and gaskets but also other ones that would keep your machine in top running condition.

La Pavoni Lever full service kit LIGHT VERSION comes with extra:

1. One sachet of descaler (Made in Italy);
2. One 5g round cap of food safe grease needed during the process of servicing but also for regular maintenance (especially the piston gaskets;
3. One exploded diagram of the EP machine.

Inside the kit you have:

1 x Boiler cap seal
1 x Heating element seal (old type)
1 x Steam tap rubber washer
2 x Steam wand connection seals
2 x Sight glass seals
1 x Group shaft tie rod gasket
2 x Piston gaskets
1 x Filter holder gasket (old round type)
1 x Group head to boiler gasket

We made some of these gaskets from Silicone material and are available exclusively from Coffee Sensor Gaskets Division here – click to view.

DISCLAIMER

All the gaskets sold on my website are tested personally on the exact machine it’s sold for.
So, I know for sure they are good and do work and are 100% compatible.
No gasket is custom made or resold BEFORE I do a personal test on my machines.

Before doing an installation, contact me directly if you feel you need guidance or info / details regarding the installation process.
Never contact me AFTER the damage is done saying that the gasket / gaskets were bad and demanding new gaskets or a refund.

Gaskets DO NOT DAMAGE by themselves and do not get cut just sitting around on the working bench, if you know what I mean.

A manufacturing fault of the gasket MUST BE DECLARED right upon receiving the product by you. Later on complaints will not be taken into consideration. I had customers claiming warranty after 1 year of purchase.

We had situations when a customer destroyed four identical gaskets and said they are bad.
After that, I sent a video with proof that it worked for me during my first try, at cold, with no preps or training before doing the video.

Even so I have sent the customer new gaskets to help out, and guess what, it seems the new ones were also bad 🙂

Take into consideration that sometimes, the tolerances during manufacturing process of the machines are what they are and even a 0.2mm deviation can make your life hard during installation.

IMHO, Coffee Sensor is not always to be blamed for small problems with the compatibility of the gaskets with some machines.

Always use grease to install any gasket from our website.
That helps them slide into position and should never get the product shredded or destroyed / pinched in any way.
Never use sharp edges like cutters, screw drivers or anything similar to help slide the gaskets into place.
That could cut the gasket and make it unusable.

I do not accept warranty claims due to bad manipulation / handling of the gaskets.
Purchase the gaskets only if you understood and read these instructions and disclaimer and accepted these terms and conditions.