La Pavoni Lever Grouphead to Boiler Silicone Gasket code 465128/3186247

La Pavoni Lever Grouphead to Boiler Gasket code 465128 is placed right between the group head of your LP and the boiler, so inside the ,,neck” of the machine.

Position 85 in the attached scheme. Please view second photo for your reference.

If you will ever get from that zone, steam or water or you see way to much play, it’s best to replace this gasket.

O-ring thickness is 2.62 mm, internal diameter is 28.25 mm.

Used with all Pavoni lever machines with two bolts on the side of the group head, starting with Gen 2 machines all the way to Gen 4 (Stradivari model).

This is one of the most prone to wear and tear gasket on La Pavoni machines, so I strongly suggest you stock up this gasket for future maintenance.

DISCLAIMER

All the gaskets sold on my website are tested personally on the exact machine it’s sold for.
So, I know for sure they are good and do work and are 100% compatible.
No gasket is custom made or resold BEFORE I do a personal test on my machines.

Before doing an installation, contact me directly if you feel you need guidance or info / details regarding the installation process.
Never contact me AFTER the damage is done saying that the gasket / gaskets were bad and demanding new gaskets or a refund.

Gaskets DO NOT DAMAGE by themselves and do not get cut just sitting around on the working bench, if you know what I mean.

A manufacturing fault of the gasket MUST BE DECLARED right upon receiving the product by you. Later on complaints will not be taken into consideration. I had customers claiming warranty after 1 year of purchase.

We had situations when a customer destroyed four identical gaskets and said they are bad.
After that, I sent a video with proof that it worked for me during my first try, at cold, with no preps or training before doing the video.

Even so I have sent the customer new gaskets to help out, and guess what, it seems the new ones were also bad 🙂

Take into consideration that sometimes, the tolerances during manufacturing process of the machines are what they are and even a 0.2mm deviation can make your life hard during installation.

IMHO, Coffee Sensor is not always to be blamed for small problems with the compatibility of the gaskets with some machines.

Always use grease to install any gasket from our website.
That helps them slide into position and should never get the product shredded or destroyed / pinched in any way.
Never use sharp edges like cutters, screw drivers or anything similar to help slide the gaskets into place.
That could cut the gasket and make it unusable.

I do not accept warranty claims due to bad manipulation / handling of the gaskets.
Purchase the gaskets only if you understood and read these instructions and disclaimer and accepted these terms and conditions.