CS-014 La Pavoni or E61 coffee machine universal thermometer with wire and diode
10,00 €
The stainless steel LP connector can be used on both sides of the group head by removing one of the bolts and installing the support between it and the group head body.
FRCompanion to the Heat Dissipation tool. It is 2 degrees off but for the purpose this is not a problem. And it would be nice if the cable was slightly shorter.
very useful
One of the best solutions for reading the temperature of the water passing through the Group Head and with the addition of the frame to hold the thermometer readout makes this addition to Tudor's list of La Pavoni solutions very welcome.
This La Pavoni or E61 coffee machine universal thermometer with wire and diode can be used to measure for example, the coffee machine group head temperature, or other hot parts, like boiler.
All you need to do is use some special thermal glue or thermal resistant duct tape, in order to stick the sensor’s diode to a certain area or zone of your La Pavoni or E61 or any other coffee machine.
La Pavoni users can use this with our bracket made from Stainless Steel, to attach this sensor to the group head, and insert the diode into a heat sink or just glue it on the boiler, to know it’s exact temperature before, during and after the coffee extraction.
The bracket is NOT included.
The thermometer’s back dimensions are: 44.7 x 25.6 mm.
The front mask is: 28.5 x 47.57 mm.
The wire is 95 mm long.
The sensor’s diode from the end of the wire has a stainless steel case and has the dimensions of: 20.17 x 3.94 mm.
The thermometer case material is ABS.
The thermometer can show ONLY Celsius units.
The sensor is always ON, so it does not have an ON/OFF button.
The latency is 1.5 seconds between readings.
| Weight | 20 g |
|---|
Related products
E61 Group head
E61 Group head
CS-007 E61 Yellow Silicone Filter Holder Gasket 73x57x8.5 mm
E61 Group head
E61 Group head
E61 Group head
La Marzocco
E61 Group head